The page will refresh and being initializing the Device Control. If your scanner is unplugged, plug the scanner in and refresh your page to begin making deposits.

If you aren’t using WiFi, plug in the ethernet cable into your router, and then into the SkyBridge unit. Once you have done that, plug in the power. Please wait at least 2 minutes. While the …

Initializing your smart card or cryptographic device IMPORTANT: These instructions are written step-by-step; do not perform an action before the instructions tell you to do so.

Very little programming is needed to initialize the device. Depending on the options selected, a maximum of two kilobits of the configuration zone might have to be programmed. This …

After the camera has been selected, click on Initialize at the top right of the menu. Be sure "Using current device password and email info." is selected and click Next. The IP Camera will take a …

It will take approximately 5 minutes after connecting the battery for the electronics to initialize. This delay is a normal part of startup. After approximately 30 seconds, the sensor LED will …

Upon completion of the Key Cycle, Turn key to ‘ON’ position and start engine. Allow engine to run until it reaches normal operating temperature. It is VERY important that when performing this …